1 help Baishuzhan to disasswemble and assemble his engine.
The oil pressure gauge is not working, so Mr yao addvice us to chech oil filter and oil pump.
Finally wew found the steel ball on the top of oil pump (which is used as a one way check valve) is not located in the centre.it is because that last time they disassemble the engine, the engine fall down and the ball drop from the right position, so when the spring press the ball, it is not sealed very well. The solution is that we put GREASE around the ball, then the engine falls, the ball is still on the right position.
2 the coolant water not go through the in-cylinder pressure senser. The tube is blocked. I clean it and it works again.
3 Set up all the test facilities, I am planning to do several other test while waiting for the delivery.
the tests are as follows
(1)Test as Clive show me about current two injector controller by scope
(2) working again for the Labview program and get in-cylinder pressure, analysis the data.
(3) Find the border of CAI combustion (I think the spart controller is not working right now)
(4) Use exhaust gas analysier to find air /fuel ratio
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment